DuraPost® Storage

Trusted by industry leaders for innovative fencing solutions

DuraPost®Storage Method Statement

This method statement covers the storage of the following DuraPost products: DuraPost® Classic, DuraPost® Commercial, DuraPost® HD, DuraPost® Sleeper T post and DuraPost® Gate and Corner Posts. Proper storage of DuraPost® products is essential to maintain their longevity and uphold warranty conditions.

1.Powder-Coated DuraPost®

Powder-coated posts are supplied with a protective self-adhesive tape on the front face.
Posts must be inspected upon delivery for any damage to the protective tape or exposed edges.
Posts should be stored at a slight angle from the horizontal to allow surface water to run off.
Posts may also be stored in a near-upright position if it can be done safely.
When using “pigeonhole” or horizontal compartment storage, care must be taken not to drag posts along their length. Ensure the correct gradient is maintained for effective water run-off.
Stock rotation should always be followed as part of good working practice.

2.Galvanised DuraPost®

Posts must be inspected upon delivery for any damage
Posts should ideally be stored indoors or under cover with adequate air ventilation.
If outdoor storage is necessary, pallets must be opened, and posts separated and placed at the correct gradient to allow water run-off.
Leaving posts strapped together restricts airflow and water drainage, which can lead to the formation of white rust over time.
Posts may also be stored in a near-upright position if it can be done safely.
Stock rotation should always be followed as part of good working practice.

Method Statement: Storage of DuraPost®Composite and PVC Fence Panels

Scope: This method statement outlines the correct storage procedures for DuraPost products, including DuraPost URBAN®, DuraPost VISTA®, DuraPost VENTO®, and DuraPost PRIMA®. Proper storage is essential to preserve product integrity, appearance, and to maintain warranty validity.

Storage Requirements

1. Protective Packaging

All factory-applied wrapping, tape, or other protective materials must remain in place until installation to prevent damage or contamination.

2. Positioning and Support

Panels must be always be stored completely flat and level.
When not stored on a full-length pallet, use timber support bearers at minimum 200 mm centres to prevent bowing or distortion.
Vertical storage is not permitted.

3. Indoor and Outdoor Conditions

Wherever possible, store all products indoors or under cover away from direct sunlight and excessive heat.
If outdoor storage is unavoidable:
Ensure pallets are well-ventilated and covered with a waterproof tarpaulin or equivalent.
Position pallets at a slight gradient to facilitate water run-off and prevent pooling.

4. Stock Rotation and Colour Variation

Due to potential minor colour/shade variations between production batches, stock rotation must be implemented as part of standard storage and installation practice.

BJA Trading t/a Birkdale 10/25